Mounting On A Wall Or A Pole - Cisco 1552S Installation Manual

Installing the 1552 Series Access Points in
Hazardous Locations
This chapter describes how to install the 1552 access point for hazardous locations and contains the
following sections:
•
•
•
•
•
•
•
•
•
•

Mounting on a Wall or a Pole

This section provides instructions for the physical installation of your access points. Personnel installing
the access point must understand wireless access points and bridging techniques and grounding methods.
All installation methods for mounting an access point on any wall surface is subject to the acceptance of
Caution
local jurisdiction.
Installation Option
The Cisco Aironet 1552 Series Outdoor Mesh Access Point for Hazardous Locations are installed using
the optional Pole Mount installation kit, which is used for pole or wall installations
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Mounting on a Wall or a Pole, page 3-45
Working with the Access Point Hinged Cover, page 3-58
Grounding the Access Point (all models), page 3-60
Installation Details for the 1552H Access Point, page 3-61
Installation Details for the 1552SA and 1552SD Access Point, page 3-63
Installation Details for the 1552WU Access Point, page 3-69
Using the Reset Button, page 3-69
Rebooting the Access Point, page 3-70
Powering the Access Point, page 3-71
Performing Maintenance, page 3-79
C H A P T E R
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
3
3-45