Table of Contents
Advertisement
Chapter 3
Installing the 1552 Series Access Points in Hazardous Locations
Check your work.
Step 7
Close the access point hinged cover. See the
Step 8
page 3-59
Connecting Ground and AC Power
When you install the conduit, be sure to comply with the local electrical codes for your area.
Note
Refer to
AIR-CAP1552SA/SD-x-K9, and AIR-CAP1552WU-A-K9 Access Point Configurations" section on
page D-22
To route and connect the ground and AC power cabling to the 1552H or 1552SA access point model,
follow these steps:
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
Always install the ground wire before connecting all power leads.
Caution
Open the access point hinged cover. See the
Step 1
page 3-58
Use a Phillips head screwdriver to loosen the three captive screws that secure the AC entry module cover.
Step 2
(Figure
for details.
"Table D-2Power Consumption Budget for the AIR-CAP1552H-x-K9,
for Power distribution details.
for instructions.
3-24).
"Closing the Access Point Hinged Cover" section on
"Opening the Access Point Hinged Cover" section on
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Powering the Access Point
3-77
Advertisement
Table of Contents
