Hand Feed Operation - Horizon Fitness SPF-20A Manual

3. Operation Procedures
3-2 Binding Operation

3-2-3 Hand Feed Operation

This section shows how to feed sheets manu-
ally.
1.
Remove connector which connected to
collator.
2.
Adjust both hand feed guides so that
they touch the sheet edges.
(1) Place a sheet on hand feed table. The
reference is slots on hand feed table.
(2) Fix hand feed guides aligning them to sheet
edge.
NOTE
- To adjust the other parts, refer to the re-
quired operation mode in "2-3 operation
mode setup".
3.
Press "Motor" icon on the binding mode
page to turn on SPF-20A.
4.
Place sheets on feed table to feed them.
Hand Feed Guide
(Operation Side)
60 min.
60 min.
Motor
68
Connector
Hand Feed Guide
(Drive Side)
Hand Feed Table
Slot