Horizon Fitness SPF-20A Manual page 103

6-3 SPF-20A Installation
7.
Change the upper cover setting height.
(1) Remove the upper cover and replace the
slide stay board with the attached slide stay
which has a deeper gutter.
(2) When setting the upper cover again, raise
the upper cover setting height by putting
the spacer in. The length of the screw
should be changed. Use attached screws
(screw set 1)
NOTE
-To prevent the spacer from falling while it is
being set, stick the spacer by both sides tape
before placing the cover.
8.
Install the rear cover of the SPF-20A.
- The connection of the SPF-20A with the
HOF-30/-20 or ST-40 is explained in the
operation manual of each machine.
Upper Cover
97
6. Move and Installation
Put the spacer in
here
Slide Stay Board