Horizon Fitness SPF-20A Manual page 101

6-3 SPF-20A Installation
1.
Remove the rear cover of the SPF-20A.
2.
Place the belt on the pulley of the rear side
of the SPF-20A.
3.
Change the two transport bolt for stitcher
and folder to the attached bolt (Big)
4.
Remove the cover stopper. Then put the
attached spacer into the attached cover
stopper, and install it.
(Applying the accessory belt)
Pulley A
If this pulley is re-
placed with the
accessory entrance
drive roller, the
sheets are smoothly
fed into the
SPF-20A and the
jam will be reduced.
This is effective when
sheets are fed with a
little overlap.
When this pulley is
installed, set the
tension pulley at the
position for the lowest
tension.
Transport
Bolt
95
6. Move and Installation
Back of SPF
main body
Nut
Bolt (Big)
SB12-25
Spacer
Cover Stopper
SB4-20