Siemens SINUMERIK 840D sl Programming Manual page 161

Nc programming

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Interpolation parameters I, J, K

Circle radius (CR)

Polar radius (RP)

Thread pitch

Programmable FRAME

Settable FRAMES

Basic frames

External work offsets

Axial preset offset

Working area limits (G25/G26)

Protection areas

Tool offsets

Length-related machine data

Length-related setting data

Length-related system variables

R parameters

Siemens cycles

Jog/handwheel increment factor

P: Writing/reading is performed in the programmed system of units.

G: Writing/reading is performed in the configured basic system

Synchronized actions

Reading position data in synchronized actions

If a system of units has not been explicitly programmed in the synchronized action (condition

component and/or action component) length-related position data in the synchronized action

will always be read in the parameterized basic system.

Further information: Function Manual, Synchronized Actions

NC programming

Programming Manual, 12/2019, 6FC5398-2EP40-0BA0

Fundamentals

2.8 Geometry settings

Show Quick Links

Table of Contents

Sinumerik 840de sl