Selecting; Changing The Navigation Map Range; Decluttering Map - Garmin G500H Pilot's Manual

3.1.3 Selecting Page Options
1) Change the fields or the setup of a page by pressing the MENU key and make
the necessary adjustments with the MFD knobs.
2) Turn the large MFD knob to select desired item.
3) Turn the small MFD knob to change the highlighted value.
4) Press ENT to accept the displayed value.
5) Press the small MFD knob to cancel selection or to end editing.
3.1.4

Changing the Navigation Map Range

The Range (RNG) keys on the right side of the bezel are used to change the
map display range. Pressing the
displayed map range) and pressing the
the displayed map range). The Map Range is shown on the outer range ring. The
map ranges available are from 250 feet to 500 NM.
3.1.5 Decluttering Map Pages
The Map Declutter feature allows the pilot to progressively step through
four levels of decluttering to remove map information. The declutter level is
displayed in the DCLTR soft key.
1) There are four levels of decluttering. DCLTR (0) shows the most detail. DCLTR-3
removes the most detail.
2) While viewing one of the Navigation Map pages, press the DCLTR soft key.
Each successive press of the DCLTR soft key will toggle through the declutter
levels. In the following table, features marked with a "•" are shown at the
indicated Declutter Level. Features shown at level 0 will be displayed at all
Declutter levels.
NOTE: Traffic is automatically decluttered from Nav Map pages when the
map scale is above 40 NM.
3-4
RNG key will zoom out (increasing the
Figure 3-5 Map Declutter Soft Key
Garmin G500H Pilot's Guide
RNG key will zoom in (decreasing
190-01150-02 Rev. J