System Display Units - Garmin G500H Pilot's Manual

Figure 3-51 Altitude and Vertical Speed MFD Display Units
3.2.1.9

System Display Units

The System Display Units options allows the selection of units to display
values for Navigation Angle (Magnetic or True), Barometric Setting (inches or
Hectopascals), and Temperature (Fahrenheit or Celsius). Pressing the DFLT
UNIT soft key will restore the Default Unit settings.
1) While viewing the System Setup page of the AUX page group, press the small
MFD knob to activate the cursor. Turn the large MFD knob to highlight the
System Display Units selection titled "Nav Angle."
CAUTION: The Nav Angle display units (Magnetic or True) must be set to
the same type in both the GDU 620 and GPS navigators.
2) Turn the small MFD knob to select Magnetic or True and then press ENT.
The Barometric Pressure Setting value will now be highlighted. When True is
selected, a "T" will appear to the right of the heading value on the PFD.
Figure 3-53 Barometric Setting System Display Units
3-38
Figure 3-52 Nav Angle System Display Units
Garmin G500H Pilot's Guide 190-01150-02 Rev. J