Garmin G500H Pilot's Manual page 211

SIGMET/AIRMET Viewing Range
The SIGMET/AIRMET Viewing Range option allows you to select the map
range where at and below that value SIGMET/AIRMET products will be shown
on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected,
SIGMET/AIRMET will not be shown. Where a value (such as 100 NM) is
selected, SIGMET/AIRMET data will be shown at map ranges of the selected
value (100 NM) and lower.
1) While viewing Weather Setup 1/2 menu, turn the large MFD knob to highlight
the SIG/AIR Viewing Range value.
2) Turn the small MFD knob to highlight the desired value. Press ENT to accept
the displayed value. The next option will be highlighted.
3) Press the small MFD knob to cancel selection or to end editing and return to
the previously viewed page or turn the large MFD knob to the next option.
Viewing Textual Sigmet/Airmets
Textual Sigmet/Airmets can be viewed by selecting the Sigmet/Airmet outline
on the Weather (WX) page.
1) While viewing a Map or Weather page, Use the small and large MFD knobs to
move the cursor to highlight a Sigmet/Airmet line. Press ENT.
2) The Sigmet/Airmet information will be shown. Press the small MFD knob to
return to the previously viewed page.
190-01150-02 Rev. J
Figure 4-41 XM Weather - AIRMETs (Text)
Garmin G500H Pilot's Guide
4-61