Changing Cdi Course - Garmin G500H Pilot's Manual

1) Press the CDI soft key to toggle between GPS and VOR/LOC source type.
2) Press 1-2 soft key to toggle between the 1 and 2 navigators of the GPS or VOR/
LOC sources.
3) Verify the navigation source by the indication on the HSI and in the upper left
corner of the PFD.
NOTE: The selected navigator is the active navigator for all PFD and MFD
operations, except for the supplemental bearing pointers.
2.7.2

Changing CDI Course

The Selected Course is shown to the upper left of the HSI for 10 seconds after
being adjusted.
New Course Setting
1) Press the CRS key to activate Course mode.
2) Turn the PFD knob to change the Course values.
OR
3) Press the PFD knob to set a Course that will center the CDI to the VOR station
or waypoint if in GPS OBS mode.
190-01150-02 Rev. J
Figure 2-27 Course Setting
Garmin G500H Pilot's Guide
2-21