Table of Contents
Advertisement
Setting Up the WAN
S
U
ETTING
P THE
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of
255.255.255.0
for the subnet mask.
1
From the
Main Menu
2
From the
LAN Setup
3
Do one of the following from the LAN Mode menu:
•
Type
1
to select
•
Type
2
to select
Browser or Telnet to manage the MM701F.
4
From the
LAN Setup
enter the values supplied by your LAN administrator or use the default values.
5
From the
LAN Setup
address supplied by your access provider.
6
From the
LAN Setup
that you have made for this session.
7
From the
Main Menu,
48
LAN
, select
LAN Setup
. The LAN setup screen displays.
1. LAN Protocol
2. IP address
3. IP Net Mask
4. Default Gateway
5. DHCP
6. DHCP Range Low Address
7. DHCP Range High Address
8. DHCP Gateway Address
9. DHCP DNS
10. Apply
Select Parameter to edit (Return to exit) ->
menu, select
LAN Protocol
Router.
Bridge
. You must configure an IP address for the LAN port to use a
menu, type
2
or
3
to select
menu, type
4
to select
menu, type
to select
10
type
5
to select
Save New System Configuration
for the Ethernet Port IP Address, and
10.0.0.1
LAN
Bridge
10.0.0.1
255.255.255.0
None
N/A
N/A
N/A
N/A
by typing
1
.
IP Address
or
IP Net Mask
Default Gateway
, then enter the
.
immediately activates the changes
Apply
Apply
(respectively), then
Default Gateway
IP
and save these settings.
MM701F User Manual
Advertisement
Table of Contents
