Checking Led Indications - ADC MM701F User Manual

Checking LED Indications

C LED I
HECKING
Your service provider sets up the ADSL parameters for your service. The MM701F must have
the DSL SYNC LED lit before you can connect sessions with your service provider.
The table below describes LED indications for all operational modes. LEDs on the MM701F
front panel provide continual status at-a-glance for network connections.
LED State
POWER On green
Off
LINK On green
Off
TX Flashing green
Off
RX Flashing green
Off
COL Flashing green
Off
SYNC On green
Flashing green
Off
TX Flashing green
Off
RX Flashing green
Off
MAR On green
Off
6
NDICATIONS
Description
MM701F has power.
MM701F does not have power.
Ethernet
A PC, hub, or other network device is connected to the MM701F
10Base-T interface.
No device is connected to the MM701F 10Base-T interface.
MM701F is transmitting data to devices on the LAN.
MM701F is not transmitting data to the LAN.
MM701F is receiving data from devices on the LAN.
MM701F is not receiving data from the LAN.
Ethernet packet collisions are occurring on the LAN.
No Ethernet packet collisions are occurring.
DSL
DSL transceiver is synchronized (connected) and in normal operation
mode.
Slow flashing green indicates that the DSL transceiver is in a start-up
or handshaking sequence. Fast flashing green indicates the DSL
transceiver is in training sequence.
DSL transceiver is not detecting a transceiver at the far end and is not
connected.
MM701F is transmitting data over the DSL connection.
MM701F is not transmitting data over the DSL connection.
MM701F is receiving data over the DSL connection.
MM701F is not receiving data over the DSL connection.
DSL margin is above the preset margin value.
DSL margin is at or below the preset margin value.
MM701F User Manual