ADC MM701F User Manual page 53

Valid values for the parameters shown on the Sessions Options screen are defined in the
following table. Unless there is a special circumstance, the default values for the remaining
parameters should not be changed.
Session Parameter
Session Name
WAN Protocol
State
IP Addressing
IP Address
IP Net Mask
NAT
RIP Send
RIP Accept
VPI
VCI
QoS
QoS Peak Cell Rate
Encapsulation
Login Name
Login Password
Authentication
Apply
MM701F User Manual
Chapter 4: Managing the Modem Using the Console Port & Telnet
Valid parameter Values
The name assigned to the session by your service
provider—up to 15 characters.
RFC1483-Router, RFC1483-Bridge, PPPoA.
Enable or Disable a session.
Static or Dynamic. Not applicable to bridging.
WAN IP address supplied by your service provider.
WAN IP subnet mask supplied by your service provider.
Enable or Disable.
Disable, RIP1, RIP2, Rip1&Rip2.
Disable, RIP1, RIP2, Rip1&Rip2.
VPI supplied by your service provider.
VCI supplied by your service provider.
Supplied by your service provider.
Supplied by your service provider.
Select VC-MUX or LLC.
PPP authentication name supplied by your service
provider.
PPP authentication password supplied by your service
provider.
Select PAP or CHAP.
Apply Settings.
47