Install Additional Wiring Harness (Only Forage Harvesters Of The Types 498) - Kemper 475plus Operator's Manual

Install additional wiring harness (only forage harvesters of the types 498)

NOTE: A wiring harness with an additional socket and
connecting cable is supplied along with this rotary
harvesting unit. This wiring harness is needed in
order to fold the rotary harvesting unit.
The supplied wiring harness must be installed on the
Claas forage harvester before attaching the rotary
harvesting unit for the first time.
To do so, proceed as follows:
1. Pull out the connector (E) from the angle sensor (D) of
the forage harvester.
2. Connect the plug connections (A) of the supplied
wiring harness between the angle sensor (D) and
connector (E) on the forage harvester.
Attaching to a CLAAS Forage Harvester
A—Plug connections
B—Socket outlet
C—Connecting cable
Continued on next page
25-5
D—Angle sensor
E—Connector
KM00321,00008BE -19-01MAR19-1/3
PN=30
040519