Kemper 475plus Operator's Manual page 33

Rotary Harvesting Units with Attaching Frame
for Support Wheel
1. Drive the forage harvester close to the rotary
harvesting unit's frame until latching hooks (A)
protrude into brackets (D) of the attaching frame.
2. Remove pins (C) on both sides.
3. Lift front shield (B) up until latching hooks (A) of the
rotary harvesting unit lie in brackets (D).
4. Secure upper bearing point by installing pin (C).
Lock lower bearing point by engaging lever (E).
IMPORTANT: Retain pin (C) and lever (E) with
spring locking pin.
5. Lock jackstands (F) on the right and left side in the
highest position. To do this, pull out spring-loaded
pin (G) and let it re-engage when the jackstand is in
its final position.
A—Latching Hooks
B—Front Shield
C—Pin
D—Bracket
Attaching to a CLAAS Forage Harvester
E—Lever
F— Jackstand
G—Pin
25-8
KM00321,00006CB -19-09OCT17-2/2
040519
PN=33