Attaching; Ballasting The Forage Harvester; Adjust Additional Lights (Claas Forage Harvester Only); Automatic Identification Of Comfort Support Wheel - Kemper 300F Operator's Manual

Ballasting the Forage Harvester

Depending on the configuration of forage harvester/rotary
harvesting unit, there may be considerable variations in
ballast requirements with the support wheel attached.
Always install sufficient ballast to ensure steering function
when braking while machine is in operation.
IMPORTANT: For correct ballasting ALWAYS refer to
the relevant ballasting chart in Section Ballast.
Adjust Additional Lights (Claas Forage
Harvester Only)
Before attaching the support wheel, adjust additional
lights (A) on forage harvester so that they are as far apart
(outward setting) as possible.
A—Additional Lights
Automatic Identification of Comfort Support
Wheel
With Comfort support wheel attached and completely
locked, rod (A) extends on both sides of the attaching
frame and transmits an impulse to the forage harvester
software via an electrical sensor.
In this way, the Comfort support wheel is identified by the
forage harvester.
A—Lift Rod
Attaching to a Rotary Harvesting Unit with
AHC (Option)
Before attaching support wheel to a rotary harvesting
unit with AHC (option), move rotary harvesting unit to
horizontal position.

Attaching

20-1
KM00321,0000167 -19-09MAY12-1/1
KM00321,000021F -19-01OCT13-1/1
KM00321,000044A -19-19MAY15-1/1
KM00321,0000220 -19-04OCT13-1/1
110515
PN=26