Check The Sensors And Adjust Them (Only Rotary Harvesting Units For Fendt Forage Harvesters) - Kemper 400F Support Wheel Operator's Manual

Check the sensors and adjust them (only
rotary harvesting units for Fendt forage
harvesters)
NOTE: Perform this adjustment only if the support wheel
is NOT recognized by the forage harvester software.
1. Take out screw (A) and pull out locking status indicator
(B) from above.
A—Screw
2. Raise the rod by 10 mm (0.39 in.).
3. Adjust the fine thread of sensor (B) such that the
sensor switches on when the rod (A) is raised by 10
mm (0.39 in.).
4. Secure sensor (B) with lock nuts.
A—Rod
Lubrication and Maintenance
B—Locking status indicator
B—Sensor
45-4
Continued on next page
KM00321,0000797 -19-02MAR18-1/3
KM00321,0000797 -19-02MAR18-2/3
031318
PN=34