Christie DWU851 Service Manual page 84

DWU851(DD1-WU70P/71P) / DHD851(DD1-HD70P/71P) / DWX851(DD1-WX70P/71P)
4) Wire the cables and attach the partition as below.
CNAC1 CNPF1
Wire CNPF1 beneath
POWER UNIT1
CIRCUIT.
Partition
5) Attach the power unit circuit case and screw down. Put CNGDS on the holder and screw down. Wire
the cables as below.
Wire CNPF2 and CNGDS
through this hole.
Power unit
circuit case
Use this groove to wire
CNPF1/2 and CNGDS
outside the case.
Use the detent to fix
the terminal direction.
M4x8 silver
screw
[CAUTION]
Make sure CNPF1, CNPF2, and CNGDS are not
pinched between the holder and the bottom case.
DWU851/DHD851/DWX851
Service Manual
020-000755-01 Rev. 1 (11-2014)
CNTS CNPW1
Wire CNAWV beneath
POWER UNIT1
CIRCUIT.
POWER UNIT1
CIRCUIT
CNAWV
Wire CNPW1 and Wire CNPW1 and
CNTS through this hole.
CNGDS
83
POWER UNIT1
CIRCUIT
Partition
Clip the partition
with the flap
Wire CNPW1 and CNTS Wire CNPW1 and CNTS
through this hole.
Outside View
Wire CNGDS on the right side
and CNPF1/2 on the left side.
Wire CNGDS beneath
CNPF1 and CNPF2.
CNPF1/2