Christie DWU851 Service Manual page 60

DWU851(DD1-WU70P/71P) / DHD851(DD1-HD70P/71P) / DWX851(DD1-WX70P/71P)
Rear side of the MAIN PCB
Wire the cables in the area surrounded with yellow dotted line according to
1. Connect and style
CNPW1 and CNPW2.
Style CNPW1 as shown
Connect CNLDD.
and all the cores turn the ties to the PCB.
at the neck, right under
the ferrite core.
3. Style CNGD1 and check the wiring if no
wire is possi ly pinched with UPPER
CASE or any other parts.
Front side of the MAIN PCB
Wire the cables in the area surrounded with red
dotted line according to the following.
Twine CNNWP, CNSSH and CNAWD
around CNLED as shown below.
CNNWP
CNSSH
DWU851/DHD851/DWX851
Service Manual
020-000755-01 Rev. 1 (11-2014)
Connect CNPW1.
LED PCB
Connect CNNWP, CNSSH, CNLED,
CNAWD, CNACR and CNRCR.
CNAWD
CNLED
Add CNPW2 to the
hook as shown.
Style CNGD1
as shown.
Make sure no wire rests on
the top of the bosses to avoid
pinching with the UPPER CASE.
LED PCB
59
following procedure.
Connect CNPW2.
REMOTE-F PCB