Using the Power Features
Operating ProntoPro NG with RF
By default, ProntoPro NG uses infrared (IR) signals to operate devices. IR signals
have an operating distance of approximately 10 m (33 ft ).
However, you can choose to have ProntoPro NG working with radio frequency (RF)
signals to operate devices from a distance or from an adjacent room.
An RF Extender (not included) is therefore required.
The SBC Li900 is an RF Extender that can be used in combination with
ProntoPro NG. The RF Extender receives RF signals from ProntoPro NG and
converts them into IR signals, sent out to the device. Therefore, the RF Extender
has to be placed near the device you are operating with the RF Extender's sending
eye pointed towards the device.