Download  Print this page

Philips SBCRU980/05 User Manual page 12

Philips pronto home theater control panel sbcru980
Hide thumbs

Advertisement

Before You Start
1 Plug the power adapter into a wall outlet and connect it to the docking
station.
2 Slide the ProntoPro NG in the docking station until it clicks.
Charging starts immediately. The blue charging LEDs on the front of the docking
station indicate that the battery pack is being charged.
When the ProntoPro NG is fully charged, the charging LEDs switch off. Normal
charging time is 2 to 3 hours, depending on the condition of the battery pack.
When the charging LEDs are flashing, an error has occurred. Try one of the
following:
Make sure the battery pack is properly installed in your ProntoPro NG.
Make sure the ProntoPro NG is placed properly in the docking station.
Check if the connector in the docking station is clean and free of obstructions.
Cool down the battery pack.
3 When the ProntoPro NG is fully charged,
take it out of the docking station.
Make sure that you first tilt
the ProntoPro NG to an angle
of 30° to 45° and then take it
out of the docking station.
User Guide
12
30° to 45°

Advertisement

loading

  Related Manuals for Philips SBCRU980/05

This manual is also suitable for:

Sbcru980/00