4 Position ProntoPro NG and the remote control as illustrated above.
5 Tap the Device for which you want to learn a Device Action.
A Learning indication appears in the upper right corner of the touch screen.
6 Press and hold the key on the other remote control for 1 second.
Make sure you press the key within 5 seconds.
If learning succeeded, you will get an OK message.
If learning failed, you will get a Failure message.
See 'ProntoPro NG will not learn commands' on page 58 for more information.
7 When you want ProntoPro NG to learn other device actions, repeat
steps 5 and 6.
8 Press the left firm key labelled
The Label Tool allows you to label a button, a device or a page. In the Label Tool
you can find a virtual keyboard. This keyboard zooms in when you tap a character.
The keyboard contains five different character sets, including a series of symbols
you can use for labelling. You use the Shift button to switch between the five
character sets on the keyboard.
For a complete list of the symbols, see 'List of Symbols' on page 61.
Customising ProntoPro NG
Make sure that you aim ProntoPro NG's learning eye at the remote control's
The distance between ProntoPro NG and the remote control should be
between 5 and 20 cm (2 and 8 inches).
below the touch screen to