Table of Contents
Advertisement
5. ADJUSTMENTS UPON INSTALLATION
Upon installation , make adjustments in reference to the
adjustment procedures given. in the table below.
No.
Check the interior and exterior of the control cabinet.
1
2
Check screw terminals for tightness.
3 Connect external cables and check.
4
Connect the power input cable.
Check connector and module locations to be sure of
positive
Check settings.
6
Check that the composite power supply unit outputs are
not short-circuited.
Check the output voltages after initially applying power.
9
Check the 1/0 signals between the NC unit and the
machine tool.
Check parameters and setting data.
12
Perform a second power application.
Check to be sure the emergency stop functions.
13
Check movement on each axis by manual feed.
14
m
15 I Adjust the servo system.
16 Check that all NC functions operate successfully.
Table 5.1
Adjustment Procedures
Procedure
connections.
(Cent'd)
Remarks
I
Advertisement
Table of Contents
Troubleshooting
