Display And Writing Of Fixed Files - YASKAWA YASNAC i80 Maintenance Manual

8.2 DISPLAY AND WRITING OF FIXED FILES

Each fixed file permits screen display, writing, and 1/0
verification.
Table 8.1
I t e m
Parameter
P a r a m e t e r
Offset
Coordinate System
I
Life Management
T I
OO
Macro Program Common Variable
System number and interlock have the following rules:
For writing of parameters and keep memory, system number must be set to 1.
A system number is set by the parameter replacement switch on the control panel
or to the value pmO109.
2. Setting of parameter replacement switch
OFF: SYSTEM ( pmO109 = O). Normal operation is performed
Writing of parameters is prohibited,
ON: PARAMETER (pmO109 = 1). Selected to write parameters.
Cycle start is prohibited.
When other than the values shown above is specified, normal operation cannot be
3.
guaranteed.
4. Effective only when the system number switch on the FC200 board is set to O.
System number setting pmO109 must be used as O, except when writing parameters
5.
Display, Writing, and 1/0 Verification of Fixed Files
Display Screen and
Write Process
Maintenance
maintenance, Drive Not available Maintenance Not available
Maintenance
Maintenance
Step
Step
Step
Drive
I
System No.
Interlock ,
Available
Maintenance
Available Maintenance
Available
Maintenance
Not available I Maintenance Not available
I
Not available Maintenance Not available
Not available Maintenance Not available
Not available Maintenance Not available
System No.
Interlock
Available
Available
Available
I
205