6.1 NC
RACK (Cent'd)
6.1.6 MODEL JANCD-FC222/FC224
(1) Removal
( 2 ) I n s t a l l a t i o n
(a) Check the model and REV number of the replacement
(b)
(c)
154
I
Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit is
off], loosen the mounting screw in the figure, and
remove the module from the NC rack.
See the figure for the exterior of the module.
module for consistency.
Check that the ROhl number and label contents of
the replacement module are the same as those of the
module to be replaced.
the module in line with the guide of the NC
Insert
rack and tighten the mounting screw.
c :
J