Fin Wait Occurs By Spindle Related Instruction - YASKAWA YASNAC i80 Maintenance Manual

4.3.13 FIN WAIT OCCURS BY SPINDLE RELATED INSTRUCTION

The seq
and was
Cause of Trouble
A signal identical with
the spindle speed is not
entered.
The axis zero speed
signal is not entered.
Other
then discontinued.
4 . 4 2 Fin Wait
O c c u r s by
C h e c k M e t h o d
If this trouble occurs at the time of commandl If no trouble is found in the
issuing such as " M03 S1OO", etc., confirm
1/0 signal pm3111 D, = 1 (pm3121 DC for
2nd-spindle).
Refer to the circuit diagram of the machine
manufacturer to confirm 1/0 input section
1/0 signal #1000 level.
If this trouble occurs at stop time " M05°,
refer to the circuit diagram of the machine
manufacturer to confirm 1/0 input section
1/0 signal #1000 level.
If this trouble occurs at the time of " M19°
or "M20", spindle orientation command,
refer to the circuit diagram of the machine
manufacturer to confirm the 1/0, especially
the orientation-related sections.
S o l u t i o n
I
wiring, there is a possibil-
ity of a fault model JAN CD-
drive unit.
Contact your YASKAN7A
representative.
If no trouble is found in the
wiring, there is a possibil-
ity of a fault model JANCD -
FC800 board or fault spindle
drive unit.
If no trouble is found in the
wiring, there is a possibility
of a fault model JANCD -
FC800 board or fault spindle
drive unit.
Contact your YASKA\VA
representative.
125