Table of Contents
Advertisement
6.1 NC RACK
6.1.16 MODEL JANCD-FC420
( 1 ) Removal
(a) Check that AC input power is not supplied [the
(b) Loosen the mounting screw in the figure and
(2) Installation
(b)
174
(Cent'd)
I
i
I
SOURCE indication lamp (green ) of th; power unit
is off], then pull out the CN43 cable.
remove the module from the NC rack.
See the figure for the exterior of the module.
Check the model and REV number of the replacement
module for consistency.
Check that the RON! number and label contents of
the replacement module are the same as those of the
module to be replaced.
SCREW
I
I
Advertisement
Table of Contents
Troubleshooting
