Reversing Dryer Door Swing - Whirlpool CGD9150GW Installation Instructions Manual

Remove the Door Assembly
1. Place a towel or soft cloth on top of dryer or work space
to avoid scratching of the surface.
2. Remove 3 of the 4 screws that hold the door hinge on the
front panel of the dryer. Partially loosen the remaining screw
with keyhole opening and lift the door off the screw.
3. Lay the door assembly on a previously prepared flat surface
with the inside (inner door assembly) facing up, and remove
6 phillips-head screws to release outer door assembly from
inner door assembly.
NOTE: It is important that you remove only the 6 indicated
screws.
REVERSING DRYER DOOR SWING (OPTIONAL)
4. Lift the inner door assembly off outer door assembly.
5. Remove 4 Phillips-head screws to release center insert from
outer door ring.
6. Lift and rotate center insert 180 degrees.
7. Reassemble the center insert and outer door ring with the
4 screws
25