Reversing Dryer Door Swing - Whirlpool W10184585B Installation Instructions Manual

REVERSING DRYER DOOR SWING
You can change your door swing from a right-side opening to
left-side opening, if desired.
Remove the Door Assembly
1. Place a towel or soft cloth on top of work space to avoid
scratching of the surface.
2. Open dryer door. Remove button screws from cabinet side
of hinges. Loosen (do not remove) top screws from cabinet
side of hinges.
7. Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed.
door catch
plugs
8. Reattach screws at top, bottom, and side of door (5 screws).
hinges
3. Lift door until top screws in cabinet are in large part of
hinge slot. Pull forward off screws. Set door (handle side up)
on top of towel. Remove top screws from cabinet.
4. Remove screws attaching hinges to door.
5. Remove screws at top, bottom, and side of door (5 screws).
9. Attach door hinges to dryer door so that larger hole is at the
bottom of the hinge and the hinge pin is toward the door
front.
6u
Holding door over towel, grasp sides of outer door and
gently lift to separate it from inner door. Do not use a putty
knife to pry apart. Do not pull on door seal or plastic door
catch.
10. Remove the 4 screws that attach 2 plugs on the left side.
Attach plugs to right side using the same 4 screws.
11. Insert screws into bottom holes on left side of cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
12. Close door and check that door strike aligns with door
catch. If needed, slide door catch left or right within slot
to adjust alignment.
24