Table of Contents
Advertisement
section 5 : TAIL WHEEL & RUDDER
BOTTOM - VIEW / Unteransicht
.........2
2x10mm screw
.........2
section 6 : MAIN LANDING GEAR
4X20mm screw
.....6
Fit the 2 x undercarriage
legs using the 4 x 20mm
screws provided.
* WARNING: When removing any covering
from the airframe, please ensure that you
secure the cut edge with CA or similar glue.
This will ensure the covering remains tight.
A B
5min.
epoxy
BOTTOM - VIEW / Unteransicht
6
Using 5 min epoxy glue the barbed hinge
points into the vertical stabilizer. When the
glue has set fit the 2 supplied springs
between the rudder steering arm and tail
wheel steering arm.
Drill 2 x 2mm holes as shown and fit the
horizontal stabilizer rigging points using 2 x
10mm screws.
2x10mm
2mm
Cut away the covering from
the area shown.
Advertisement
Table of Contents
