Table of Contents
Advertisement
LANDING GEAR INSTALLATION:
Remove the landing gear mounting strap from the supplied fiber sheet and find the M1.5x6 tmm self-
tapping screws in one of the accessory bags. Attach the wire landing gear to the fuselage using the
self-tapping screws to secure it in place. Note: The set of wing strut joiners on the landing gear
should be positioned towards the rear of the fuselage.
WHEEL INSTALLATION:
Install and secure the set of wheels by using the supplied wheel collars as shown. After installation,
spin the wheels to see if there is any friction and adjust the wheel collars accordingly. If need be,
use a 2.0 mm drill bit to slightly enlarge the hole size or adjust the wheel collars to ensure the
wheels spin freely. Apply a small spot of thread lock glue to the grub screws on the wheel collars to
prevent them from loosening in flight.
3
Advertisement
Table of Contents
