Table of Contents
Advertisement
section 13 : ELECTRIC MOTOR and COWLING
Using a aluminum motor mounting plate as a template, mark the fire-wall
where the 4 holes are to be drilled (1).
Remove the aluminum motor mounting plate and
drill a 5mm hole through the plywood at each of the
4 marks (2).
Note: The aluminum motor mounting and
screws included with the motor, they are not
supplied with the kit.
Note: The distance between the firewall
and the face of the prop driver should be
150mm.
Trim the cowling as shown and fit the parts using CA
glue for the dummy engine cylinders.
1
3
CA
B=150mm
B
Cut a hole in the firewall to allow you
to move the battery forward and aft so
that you can achieve the correct
balance point of the Cub.
12
Li-po battery
CA
2
4
Advertisement
Table of Contents
