H-KING NE-1 NAVY GUB Instruction Manual page 12

section 12 : ENGINE
Aluminum motor
mounting plate
1
13/64"
5mm
2 Drill the 4 holes using
a 5mm drill.
3
Now go to page 14 if using a gas or
glow engine.
If fitting a gas or glow engine then follow the instructions on this
page, if fitting an electric motor go to page 12.
Using a aluminum motor mounting plate as a template, mark the fire-wall
where the 4 holes are to be drilled (1).
Remove the aluminum motor mounting plate and drill a 5mm hole
through the plywood at each of the 4 marks (2).
Note: The aluminum motor mounting and screws are included with the
engine, they are not in the kit.
4
5
B=150mm
B
6
Distance from the firewall to the
face of the prop driver should be
150mm.
11
5X80mm screw
.........4
5mm washer
..................12
5mm nut
..................12