Main Wing Installation; Prop And Spinner Installation - H-KING MX2 Extreme 4S EP0 Instruction Manual

3d airplane

Table of Contents

Main wing installation.

Install the carbon wing joiner rod through the fuselage. Then slide the left wing panel onto the rod and

feed the aileron servo lead through the hole in the fuselage at the same time. Secure the wing panel by

using the supplied nylon wing bolt. Repeat the above steps for the right wing panel installation.

1. Install the prop hub adapter onto the motor shaft.

2. Install the spinner back plate onto the prop adapter, followed by the propeller.

3. Install the washer and the M8 nut, tighten the nut with a spanner. Attach the spinner nose cone to

the backplate using the supplied self-tapping screws. You may need to adjust the backplate and the

spinner cone accordingly by loosening the prop nut and moving it a fraction until the screw holes are

perfectly aligned together.

4. When you are satisfied with the fit, tighten the prop nut

and secure the spinner with the self-tapping screws.

Note: To achieve the best possible power and

performance from the power train as well

as ensuring you reduce the vibration on the airframe,

always balance the propeller and

spinner properly before flying.

Table of Contents