Chapter 3
Installation
Remove the dust plugs from the duplex MU optical adapter in the next HFM.
Step 6
Step 7
Clean and inspect the optical-fiber jumper cable connector in the first HFM.
Step 8
Connect the duplex MU optical-fiber jumper cable connector to the next module.
Step 9
Repeat Steps
CMX half, or a CMY.
Step 10
Repeat the procedure for both the A and B sides, if applicable, and with other MCUs, if applicable (using
CMX and/or CMY).
When the modules are connected, see
should look like (with a BM module installed).
Figure 3-30 The ONS 15252 MCU passive optical shelf after the modules are connected
78-13765-01
3–8
until all modules have been interconnected, ending with either a BM half, a TM, a
Figure 3-30
for an example of what the passive optical shelf
Cisco ONS 15200 Installation, Setup, and Test Manual
3-41