Cisco ONS 15200 Series Installation, Setup & User Manual page 8

Figures
Figure 3-27 Side view of a CMX module
Figure 3-28 Side view of a CMY module
Figure 3-29 Installing a Dummy Filter module in an ONS 15252 MCU
Figure 3-30 The ONS 15252 MCU passive optical shelf after the modules are connected
Figure 3-31 Installing an ONS 15252 MCU Network Adaptation module (Part 1)
Figure 3-32 Installing an ONS 15252 MCU Network Adaptation module (Part 2)
Figure 3-33 Installing an ONS 15252 MCU Network Adaptation module (Part 3)
Figure 3-34 An installed ONS 15252 MCU Dummy Network Adaptation module
Figure 3-35 The cover lid of the ONS 15201 SCU Collector Filter module
Figure 3-36 Position of retaining screws on the Collector Filter module cover lid
Figure 3-37 ONS 15201 SCU rear connector cover and retaining screws
Figure 3-38 CFM for an unprotected channel (100/0 or 0/100)
Figure 3-39 CFM for a protected channel (90/10, 10/90, or 50/50)
Figure 3-40 90/10 split ratio (protected) connections
Figure 3-41 10/90 split ratio (protected) connections
Figure 3-42 50/50 split ratio (protected) connections for a CFM
Figure 3-43 0/100 split ratio (unprotected) connections for a CFM
Figure 3-44 100/0 split ratio (unprotected) connections for a CFM
Figure 3-45 MCU CAN-bus access points
Figure 3-46 SCU CAN-bus access points
Figure 3-47 Jumpers on the MCU backplane
Figure 4-1 Communication Interface module connections
Figure 4-2 An OSA-to-LM connection
Figure 4-3 Attenuators from the A Side and B Side Line modules
Figure 4-4 Daisy-chained CLIP modules
Figure 4-5 ONS 15201 SCU management access interface
Figure 4-6 ONS 15201 SCU CLIP Module A side and B side with attenuators
Figure 4-7 ONS 15201 SCU in a daisy-chain configuration
Figure 4-8 ONS 15200 system span test connection (hub configuration)
Cisco ONS 15200 Installation, Setup, and Test Manual
viii
3-37
3-39
3-49
3-49
3-50
3-50
3-51
3-51
3-52
3-54
3-54
3-55
4-3
4-8
4-9
4-11
4-14
4-18
3-40
3-41
3-43
3-44
3-45
3-46
3-47
3-48
3-48
4-16
4-20
78-13765-01