Figure 4-1 Communication Interface Module Connections - Cisco ONS 15200 Series Installation, Setup & User Manual

Chapter 4 Turn Up and Test
Figure 4-1
CIM
Step 2 Use HyperTerminal to configure the RS-232 parameters listed in
following steps for an example of the procedure you may follow when using HyperTerminal.
Note The steps in this procedure are an example of the steps you might follow when using HyperTerminal
to configure the RS-232 parameters. Not all HyperTerminal installations are the same. The following
example lists the necessary steps when using the Microsoft Windows NT operating system.
Choose Start > Programs > Accessories > Communications > HyperTerminal. HyperTerminal
a.
opens.
On the Connection Description dialog box, type a session name and click OK.
b.
On the Connect To dialog box, choose COM1 from the Connect Using drop-down list. Click OK.
c.
On the COM1 Properties dialog box, choose the port settings shown in
d.
OK.
Choose File > Properties.
e.
78-13765-01
Communication Interface module connections
NCB
LEGEND
CIM - Communication Interface Module
NCB - Network Control Board module
Table 4-1 on page
Cisco ONS 15200 Installation, Setup, and Test Manual
4-4. See the
Table 4-1 on page 4-4. Click
4-3