Chapter 3
Installation
Figure 3-24 Installing a Line module in an ONS 15252 MCU
LM
Procedure: Position the Hub Filter Modules in the ONS MCU 15252 Passive Optical Shelf
This procedure explains how to insert the Hub Filter modules (HFMs). However, before actually
connecting the HFMs as described in the
Modules" procedure on page
•
•
•
78-13765-01
3-40, you must install the following modules:
The Bridge module (BM), described in the
Passive Optical Shelf" procedure on page
"Install the Termination Module in the ONS 15252 MCU Passive Optical Shelf" procedure on
page
3-36.
Any Connection Module Xs (CMXs), described in the
15252 MCUs" procedure on page
a Connection Module Y in Two ONS 15252 MCUs" procedure on page
Any Dummy Filter modules (DFMs), as described in the
Module in the ONS 15252 MCU" procedure on page
"Interconnect the ONS 15252 MCU Passive Optical Shelf
"Install the Bridge Module in the ONS 15252 MCU
3-35, or the Termination module (TM) described in the
"Install a Connection Module X in Two ONS
3-37, or Connection Module Ys (CMYs), described in the
"Install the Dummy Network Adaptation
3-45.
Cisco ONS 15200 Installation, Setup, and Test Manual
"Install
3-38.
3-33