Table of Contents
Advertisement
Installation
This chapter provides instructions for installing Cisco 15200 units, which include assembled-to-order
Cisco 15252 Multichannel Units (MCUs) and individual MCU components, and assembled-to-order
ONS 15201 Single-Channel Units (SCUs) and individual SCU components. This chapter also explains
how to install a new channel on an MCU and how to link multiple nodes to accommodate additional
traffic.
The instructions in this section primarily address the installation of the ONS 15252 MCUs, ONS
Note
15201 SCUs, and modules supplied by Cisco Systems. When installing racks, electrical wiring,
raceways, and other equipment not covered in this manual, you should follow all local, state, federal,
or international (if applicable) codes and regulations.
3.1 Installation Overview
You should be thoroughly familiar with the instructions in this manual before starting any work. Use the
following general order of work when installing a site:
Step 1
Read and observe all safety cautions and warnings in
When you arrive at the site, first verify the ONS 15200 equipment according to the procedures in
Step 2
Chapter 2, "Pre-Installation Procedures."
Technical Assistance Center (TAC) at 1-877-323-7368.
Step 3
If you do not install the equipment when it arrives, store as specified in
Procedures."
Step 4
Unpack equipment only after preparing the site as described in
When installing equipment at a site, follow the procedures in this chapter in the order presented.
Step 5
Step 6
Turn up and test the ONS 15200 system as described in
Make connections using the information in
Step 7
78-13765-01
C H A P T E R
Chapter 1, "Safety Summary."
If there is a problem with the equipment, contact the Cisco
Chapter 2, "Pre-Installation Procedures."
Chapter 4, "Turn Up and Test."
Chapter 5, "Connectors and Cabling."
Cisco ONS 15200 Installation, Setup, and Test Manual
3
Chapter 2, "Pre-Installation
3-1
Advertisement
Table of Contents
