GE Agile P50 Series Technical Manual page 89

P50 Agile P153
IN2>1 2H Blocking
Disabled
Note:
2.3.16.8 Group1 –Thermal Overload Submenu
Edit Settings
2.3.16.8.1
GROUP 1
THERMAL OVERLOAD
Characteristic
Disabled
Edit Settings
2.3.16.8.2
GROUP 1
THERMAL OVERLOAD
Characteristic
Single
Thermal Trip
1.00 A
P153/EN M/B
The settings of IN2>2 Function and IN2>3 Function to be done in similar manner as that of
IN2>1
Function.
(if Thermal overload Characteristic is disabled)
(if Thermal overload Characteristic is set as Single)
Editable setting
By using the (5) or (6) key, IN2>1 2H Blocking function can be
Enabled / Disabled.
Password protected window for "GROUP 1'' settings:
SYSTEM CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 1 Setting will be seen only when it is enabled in
Configuration setting.
Password protected window for Thermal Overload i.e. Characteristic
(Disabled/Single), Thermal Trip, Thermal Alarm, Time Constant 1 and K.
Editable setting
By using the (5) or (6) key, Characteristic is set as Disabled
Password protected window for "GROUP 1'' settings:
SYSTEM CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 1 Setting will be seen only when it is enabled in
Configuration setting.
Password protected window for Thermal Overload i.e. Characteristic
(Disabled/Single), Thermal Trip, Thermal Alarm, Time Constant 1 and K.
Editable setting
By using the (5) or (6) key, Characteristic is set as Single
Editable setting
By using the (5) or (6) key, Thermal Trip can be set. The setting
range is from 0.1 to 4.00 In in steps of 0.01 In.
5 Configuration
5-51