Display - ABB AWT420 Operating Instruction

AW T4 2 0 | U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | O I/A W T4 2 0 - E N R E V. B

Display

Menu
Display
Exit Select
Menu Comment
Language
Select the display language:
English/German/French/Italian/Spanish.
Operator Templates
Page 1 (to 5) Template Refer to page 27 for Operator Template examples.
Note. Operator Page templates are assigned automatically to display all sensors currently connected
and cannot be changed – see page 27.
View/Log Enables Select to enable/disable the following Views and Logs.
Diagnostics View
Signals View
See page 29 for examples of Operator pages in View mode.
Chart View
Alarm View
Analog OP View
Calibration Log
Alarm Log
See page 30 for examples of Operator pages in Log mode.
Audit Log
Diagnostics Log
Chart View Note . Chart View menus displayed only when Chart View is enabled.
The chart displays the primary analog value from the sensor.
Channel S1 (to S2)
Source Chart View channel sources are assigned automatically and cannot be changed.
Tag
Enter an alphanumeric tag (3 characters maximum) to identify the sensor signal on the chart.
Chart Duration
Select a chart duration:
1, 2, 4, 8, 12, 16, 20, 24 hours
Used to select the display language, setup Operator page templates (1 to 3), enable diagnostic,
view and log functions, set the device's display brightness/contrast and set the time and date.
39
Default
English
Enable (all)
TAG1
1 h