Sensor Setup; Device Setup - ABB AWT420 Operating Instruction

38 AW T4 2 0 | U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | O I/A W T4 2 0 - E N R E V. B
... 13 Configuration (Advanced access level)

Sensor Setup

Menu
Sensor Setup
Exit Select
Menu
Comment
S1: <Sensor Type> Note. Displayed only if a sensor is fitted to slot 1.
S1: <Sensor Tag> Access the sensor 1 specific setup pages, refer to the Sensor setup section (page <?>).
S2: <Sensor Type> Note. Displayed only if a sensor is fitted to slot 2.
S2: <Sensor Tag> Access the sensor 1 specific setup pages, refer to the Sensor setup section (page <?>).
Hold Outputs Note. Displayed only if two 2-electrode conductivity sensors are fitted.
Access the Calculated Values specific setup pages, refer to the Sensor setup section (page <?>).

Device Setup

Menu
Device Setup
Exit Select
Menu
Comment
Initial Setup
Instrument Tag Enter an alphanumeric transmitter identification tag
(16 characters maximum)
Temperature Units Select the units in which all temperatures are displayed:
• °C/°F
Security Setup
Calibrate Password Set the password to enable access at Calibrate level.
Advanced Password Available only at Advanced access level.
Service Access
Service Password
Reserved for use by authorized ABB service technicians
Write Protection
Restore Defaults Select to restore ALL transmitter configuration parameters to their default values and restart the transmitter.
Used to access standard setup parameters.
Note. Sensor Setup menus are sensor-specific – refer to the Calibration section (page 55)
and relevant sensor manual for full details of sensor setup.
Used to access standard setup parameters.
Default
Default
AWT420
°C
Not factory-set
Not factory-set
Set at factory