Status Bar Icons; Log Icons - ABB AWT420 Operating Instruction

AW T4 2 0 | U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | O I/A W T4 2 0 - E N R E V. B

Status bar icons

Note. Refer to page 83 for diagnostic (NAMUR) icons and
descriptions.
Operator menu – displays the Operator menu when the
key is pressed.
Autoscroll – indicates that Operator pages are displayed
sequentially. Displayed only when Autoscroll enabled from
the Operator menu.
Disabled if 1 Operator page only is configured for display.
Calibration – shortcut access to the Calibration page when
the key is pressed.
Enter – selects the highlighted option from the Operator
menus when the
Service Level*
Advanced Level* – indicates that Advanced Level parameters
are enabled for the current user.
Calibrate Level* – indicates that the Calibration Level
parameters are enabled for the current user.
Read Only Level* – indicates that the transmitter is in Read
Only mode. All parameters are locked and cannot be
configured.
High process alarm active/inactive.
Low process alarm – active/inactive.
High latch alarm – active/inactive.
Low latch alarm – active/inactive.
*Not displayed at Operator levels.
key is pressed.

Log icons

Source: sensor 1 (red)
S1 T1
S1 = sensor 1 process value.
T1 = sensor 1 temperature.
Source sensor 2 (green)
S2 T2
S2 = sensor 2 process value.
T2 = sensor 2 temperature.
Power failed/power restored.
Configuration changed.
System Error.
File created.
Media inserted/removed.
Media on-line/off-line.
Media full.
Date/time or daylight saving start/end changed.
High process alarm active/inactive.
Low process alarm – active/inactive.
High latch alarm – active/inactive.
Low latch alarm – active/inactive.
Alarm acknowledged.
35