ABB AWT420 Operating Instruction page 96

96 AW T4 2 0 | U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | O I/A W T4 2 0 - E N R E V. B
...17 Specification
...Approvals, certification and safety
...Bluetooth
• United States/FCC ID: A8TBM71S2
U.S.
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
recieved, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
• Canada/ISED
– IC: 12246A-BM71S2
– HVIN: BM71BLES1FC2
Canada
Contains transmitter module
IC: 12246A-BM71S2
This device complies with Industry Canada's license-
exempt RSS standard(s).
Operation is subject to the following two conditions:
– This device may not cause interference, and
– This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence.
L'exploitation est autorisée aux deux conditions
suivantes:
– l'appareil ne doit pas produire de brouillage, et
– l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement
• Taiwan/NCC No: CCAN16LP0011T7
Taiwan
CCAN16LP0011T7
注意 !
依據 低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，
非經許可，
公司、 商號或使用者均不得擅自變更頻率、 加大
功率或變更原設計
之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安
全及干擾合法通信 ；
經發現有干擾現象時， 應立即停用， 並改善至無
干擾時方得繼續使用。
前項合法通信， 指依電信規定作業之無線電信。
低功率射頻電機須忍受合法通信或工業、 科學及
醫療用電波輻射性
電機設備之干擾。
DS/AWT420-EN Rev. A