Table of Contents
Advertisement
INSTALLATION
Input Power
Warning:
As shown in Figure 23 below connect input power to the remote transmitter's 3-position Phoenix connector P1 on the power supply board.
The power connector accepts 24-12 AWG (0.2 mm
cabling through a conduit opening/cable gland at the bottom of the transmitter's NEMA 4X enclosure. A socketed radial lead fuse provides
input power overload protection. Refer to
26
Install an AC line disconnect switch with fuse or breaker between the power source and the flow meter.
Always disconnect power before performing maintenance on wiring.
Power Fuse
Figure 23 – Input Power and I/O Connections
-2.5 mm
) wire (refer to
Table
2
2
Replacement, page
86
(MAINTENANCE section) for fuse replacement details.
MT100 Multipoint Flow Meter
2, page
23
for wire size vs. length info). Route the power
8 7 6 5 4 3 2 1
8
7
6
5
4
3
2
1
Fluid Components International LLC
Advertisement
Table of Contents
Troubleshooting
