Table of Contents
Advertisement
5-3-8
Book Mount Procedure
Use the following procedure to mount the IPC Application Controller in the book orientation.
Additional Information
• Refer to 5-4-2 Ground on page 5-21 for grounding details.
• Refer to 2-9-1 Mounting Brackets on page 2-18 for the bracket model.
To mount the IPC:
1
The IPC has on one side light grey circles around the threaded mounting holes. The book-
mount bracket has on the inside on one side also the light grey circles around the mounting
holes.
The light grey circles are contact areas that ensure a good electrical conductivity.
Position the IPC inside the bracket so the light grey circles of the bookmount bracket contact
the light grey circles of the IPC.
2
Mount the bracket A to the IPC C with the 6 Phillips screws B supplied with the bracket.
First tighten the 3 screws at the side of the contact areas with a torque of 0.6 N·m.
Then tighten the 3 screws at the opposite side, also with a torque of 0.6 N·m.
The bracket and the IPC can differ depending on the product configuration.
3
Mount the IPC with the bracket in position.
• Arrange the two or four holes at the location where the IPC with bracket will be mounted.
Refer to 4-1-8 Bracket Specifications on page 4-9 for details.
• Position the IPC with bracket in the mounting location.
• Insert screws through the bracket and into or through the mounting surface.
Note that these screws are not in the scope of delivery.
• Tighten the screws with a torque matching the screw size and the mounting materials.
The IPC is mounted.
IPC Application Controller User's Manual (I632)
A
B
C
5 Installation
5
5-19
Advertisement
Table of Contents
