Auto Teach Screen; Hardware Usage Tracking Screen - Agilent Technologies Magnis NGS Prep System User Manual

Auto Teach screen

Purpose: To run auto-teaching,
are printed on the empty deck.
Verification"
To open: From the Home screen, press Settings. On the Settings screen press Auto Teaching.
Figure 46 Auto Teach screen
Start
Starts the auto-teaching process.
NOT E
Close
This button returns you to the Settings screen.

Hardware Usage Tracking screen

Purpose: To track the usage of the system's UV tube. For Agilent engineers and Agilent authorized
service providers, to reset the tracker following replacement of the UV tube. See instructions in
"Replacing the UV Tube and Viewing UV Tube Usage"
To open: From the Home screen, press Settings. On the Settings screen press Hardware Usage
Tracking.
Magnis and Magnis Dx NGS Prep System User Guide
a process that locates and records the positions of the teach points that
See instructions in
on page 43.
At a particular points during the auto-teaching process, the system prompts
you to perform specific actions. Monitor the touchscreen during auto-teaching
for instructions.
"Running Auto-Teaching and Teach-Point
on page 53.
69