Operating The System - Agilent Technologies Magnis NGS Prep System User Manual

Magnis/Magnis Dx NGS Prep System
User Guide
4

Operating the System

Running Protocols
Prepare the instrument for running a protocol
Prepare the reagents and plasticware
Set up and initiate the protocol run
Collect final library samples and clean up the system
Running and Viewing Diagnostic Tests
Perform instrument diagnostic tests
View reports for diagnostic tests and instrument health checks
Decontaminating with UV Light
Run a decontamination "quick cycle"
Run a UV decontamination "extended cycle"
Running Auto-Teaching and Teach-Point Verification
Run auto-teaching
Include teach-point verification in the IHC
Installing Updates
Install protocol updates
Install firmware updates
This chapter contains instructions on operating the Magnis/Magnis Dx NGS Prep System,
including running protocols, performing diagnostic tests, decontaminating the instrument deck,
running auto-teaching, and installing protocol and software updates.
N OT E
C AU T I ON
35
36
38
38
41
41
43
45
45
47
To avoid introducing contaminants, always wear gloves when operating the
Magnis/Magnis Dx NGS Prep System.
Keep the humidity levels in the laboratory between 30% and 70%
non-condensing. Operating the system in humidity levels outside of this range
can impact performance.
35
35
37
42
43
44
39
34