SMART Embedded Computing PrAMC-7311 Installation And Use Manual page 20

Safety Notes
representative system to show compliance with the above mentioned requirements. A
proper installation in a compliant system will maintain the required performance. Use only
shielded cables when connecting peripherals to assure that appropriate radio frequency
emissions compliance is maintained.
Operation
Product Damage - Surface of the Product
High humidity and condensation on the product surface causes short circuits.
Do not operate the product outside the specified environmental limits. Make sure the
product is completely dry and there is no moisture on any surface before applying power.
Overheating and Product Damage
Operating the product without forced air cooling may lead to overheating and thus damage
of the product.
When operating the product, make sure that forced air cooling is available in the shelf.
Data Corruption
If power to the blade is removed while the BIOS is still updating changes to the flash, the
changes will not be saved, and worse, the flash may be corrupted.
Whenever you select the Exit Saving Changes option to save changes to BIOS setup and
exit, do not power the blade down before BIOS reboots.
Product Damage or Loss of Regulatory Compliance
The serial port is meant for development/debug/craft purpose only.
The serial cable is not meant to be connected during normal field operation. The
PrAMC-7311 has not been qualified for regulatory compliance with the serial cable
connected.
System Malfunction
Incorrect BIOS settings can cause the system to malfunction.
To rectify mistakes use <F2> on the keyboard to return to setup and restore the system
defaults by pressing <F9>. Alternatively you can press <F2> to return to the BIOS setup
and go to the Exit menu and select Load setup Defaults.
20 PrAMC-7311 Installation and Use (6806800P34F)