ICP DAS USA PISO-DNS100-D/T User Manual page 69

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Step 5 : Wait for the Master Request
This step is waiting for the request command form the remote master
device. The user should make the master device to communicate with these
two devices. If these two virtual slave devices have communicated with the
master device successfully, the users can go to next step until the connection
of the virtual slave devices have been established.
Step 6 : Read and Write I/O Data
If the master is communicating with the virtual slave device successfully,
the users can read the output I/O data from the master device and write the
input I/O data to the master device in this step. It is shown as Figure 6.4.4. It
would obtain the output I/O data and show them in byte. The users can push
the "Set Input to 0x00" or "Set Input to 0xFF" buttons to change the input data.
The users can push the "Get Output Data" to get the output I/O data and it
would show the output value in the edit field below.
PISO-DNS100(U) DeviceNet Slave API functions User's Manual (Ver: 1.1)
Figure 6.4.4 Access IO Data
2010/01/07 69